Murano AWD V6-3.5L (VQ35DE) (2009)
Refrigerant Pressure Sensor / Switch: Service and Repair
Removal And Installation
REFRIGERANT PRESSURE SENSOR
Removal and Installation
REMOVAL
1. Remove liquid tank. Refer to See: Receiver Dryer/Service and Repair/Exploded View.
2. Fix the liquid tank (1) with a vise (A). Remove the refrigerant pressure sensor (2) with a wrench (B).
CAUTION:
-
Be careful not to damage liquid tank.
-
Seal the refrigerant pressure sensor on liquid tank with caps, vinyl tape, or a similar item to prevent them from being exposed to the
atmosphere.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
Replace the O-rig with a new one. Apply a coat of compressor oil to the O-ring prior to installation.
-
Check for refrigerant leakage when charging refrigerant.