Murano AWD V6-3.5L (VQ35DE) (2009)
Yaw Rate Sensor: Service and Repair
Removal and Installation
G SENSOR
Removal and Installation
REMOVAL
CAUTION:
Do not drop or strike yaw rate/side/decel G sensor, or do not use power tool etc., because yaw rate/side/decel G sensor is sensitive to the
impact.
1. Remove center console assembly. Refer to See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Exploded View.
2. Disconnect yaw rate/side/decel G sensor harness connector.
3. Remove mounting nuts.
4. Remove yaw rate/side/decel G sensor.
INSTALLATION
Note the following, and install in the reverse order of removal.
CAUTION:
-
Do not drop or strike yaw rate/side/decel G sensor, or do not use power tool etc., because yaw rate/side/decel G sensor is sensitive to the
impact.
-
After work, make sure to calibration of decel G sensor. Refer to See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Testing and Inspection/Programming and Relearning/Calibration Of Decel G Sensor/Description See: Brakes and Traction
Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Programming and Relearning/Calibration Of Decel G Sensor/Special
Repair Requirement.