nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

Removal and Replacement|Page 858 > < Removal and Replacement|Page 856
Page 3
background image

A : Pull
B : Push in tabs

-

If quick connector sticks to tube of main fuel level sensor unit, push and pull quick connector several times until they start to move. Then
disconnect them by pulling.

CAUTION:
-

Quick connector (1) can be disconnected when the tabs

(F) are completely depressed. Never twist it more than necessary.

B : Connection (Cross-section)
D : To under floor fuel line
E : To fuel tank
G : Disconnection

-

Never use any tools to disconnected quick connector.

-

Keep resin tube (C) away from heat. Be especially careful when welding near the resin tube.

-

Prevent acid liquid such as battery electrolyte, etc. from getting on resin tube.

-

Never bend or twist resin tube during installation and disconnection.

-

Never remove the remaining retainer (2) on hard tube (or the equivalent) (A) except when resin tube or retainer is replaced.

-

When resin tube or hard tube (or the equivalent) is replaced, also replace retainer with new one.

Retainer color: Green

Removal and Replacement|Page 858 > < Removal and Replacement|Page 856