Murano AWD V6-3.5L (VQ35DE) (2009)
CAUTION:
Never reuse boot clamp.
a. Tighten large side of boot with boot clamp (stainless wire).
Wire length (L) : 370 mm (14.57 in)
b. Wrap clamp around boot groove for two turns. Insert a flatbladed screwdriver in loops on both ends of wire. Twist 4 to 4.5 turns while pulling
them with force of approximately 98 N (10 kg, 22 lb).
c. Twist boot clamp as shown. Pay attention to relationship between winding and twisting directions.
d. Twisted area (A) of clamp is in the opposite side of adjusting screw (1) as shown in the figure (to prevent contact with other parts).
e. Bent cut end of the wire toward rack axial as shown in the figure after twisting the wire 4 to 4.5 turns so that cut end does not contact with
boot.
A : Gear housing RHD side
B : Gear housing LHD side