Murano AWD V6-3.5L (VQ35DE) (2009)
-
Make sure that the projection (C) on upper seat inside is securely fitted on the bracket (2) tabs (B).
Arrow indicates Body
-
Match up rubber seat indentions and rear lower link grooves and attach.
-
Install coil spring by aligning lower end of the coil spring to step (A) between rubber seat (1) and rear lower link (2).
CAUTION:
Set coil spring so that its paint marks are aligned with the positions of 3.5 turns (2 places) and 4.5 turns (1 place) from the bottom end of the
coil spring.
-
Perform the final tightening of rear suspension member and axle installation position (rubber bushing) under unladen condition with tires on level
ground.