Murano AWD V6-3.5L (VQ35DE) (2009)
Figure A
-
C-III PCMCIA Card Adapter is installed.
-
C-III Security Card is installed.
-
A screen print for Warranty documentation can be done from C-III during this process while still cable-connected to the vehicle.
1. Use the USB cable to connect the Vehicle Interface (VI) to the C-III computer and then connect the VI to the vehicle.
CAUTION:
For CVT reprogramming the C-III computer must be connected to the VI using the USB cable.
2. Connect the AC Adapter to the Toughbook(R) PC.
CAUTION:
Be sure to connect the AC Adapter. If PC battery voltage drops during reprogramming the process will be interrupted.
3. Connect a battery charger to the vehicle battery:
-
Set the battery charger at a low charge rate (trickle charge).
CAUTION:
If the 12 V battery voltage drops during reprogramming the control unit may be damaged.
4. Turn the ignition ON with the engine OFF.
-
The engine must be OFF (not running) during the reprogramming procedure.
5. Open / start ASIST on the C-III computer.
6. Select CONSULT Utilities, and select CONSULT-III.
7. Wait for the "Detecting VI/MI in progress" message to clear.
8. Select the detected VI from the list. (See Figure 1.)
Figure 1