Nissan and Datsun Workshop Service and Repair Manuals

Transmission Speed Sensor: Service and Repair
Removal And Installation

SECONDARY SPEED SENSOR

Removal and Installation

REMOVAL
1. Disconnect the battery cable from negative terminal.
2. Remove air duct (inlet). Refer to See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner

Housing/Service and Repair/Exploded View.

3. Remove air cleaner case. Refer to See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner

Housing/Service and Repair/Exploded View

4. Disconnect secondary speed sensor connector.

5. Remove secondary speed sensor (1) and shim (2).

CAUTION:
Never lose the shim.
6. Remove O-ring (3) from secondary speed sensor.

INSTALLATION
Note the following, and install in the reverse order of removal.

CAUTION:
-

Never reuse O-ring.

-

Apply CVT fluid to O-ring.