Murano AWD V6-3.5L (VQ35DE) (2009)
-
If joint sub-assembly cannot be pulled out, try after removing drive shaft from vehicle.
13. Remove circular clip (1) from housing assembly.
14. Remove boot from housing assembly.
INSTALLATION
1. Clean the old grease on joint sub-assembly with paper waste.
2. Fill serration slot joint sub-assembly (1) with NISSAN genuine grease or equivalent until the serration slot and ball groove become full to the
brim.
CAUTION:
After applying grease, use a paper waste to wipe off old grease that has oozed out.
3. Wrap serration on housing assembly with tape (A) to protect the boot from damage. Install boot and boot bands to housing assembly.
CAUTION:
Never reuse boot and boot band.
4. Remove the tape wrapped around the serration on housing assembly.