Murano AWD V6-3.5L (VQ35DE) (2009)
/Page-915026.png)
19. Apply anti-corrosive oil or equivalent to the bolts threads and seats, and then install and torque the bolts in a "star" pattern.
See Figure 22 for bolts location:
^
A = 45 mm (1.8 inch) bolts
^
B = 30 mm (1.2 inch) bolts
^
Bolts torque: 14-16 Nm (1.5-1.6kg-m, 10.4-11.8 ft-lb)
20. Install the pinion sleeve assembly (see Figure 23).
^ Make sure the 0-ring seal has been coated with oil.
^ Align the dowels in the correct holes.
^ Carefully tap on the companion flange to fully seat the sleeve as needed (see Figure 20).
21 Apply anti-corrosive oil or equivalent to the bolts threads and seats, and then install and torque the bolts in a "star" pattern.
^ Bolts torque: 26-33 Nm (2.7-3.3 kg-m, 20-24 ft-lb)
22. Replace the right side differential (CVT final drive) oil seal.
CAUTION:
Be careful not to scratch the seal surface when removing and installing.
23. Clean off any assembly oil / lube, remove the tape (applied in Step 14), and then install the transfer assembly.
^ Refer to the ESM, if needed.
24. Fill the transfer assembly.
^ For warranty purposes, use the gear oil listed in PARTS INFORMATION only.
^ For transfer assembly gear oil capacity and filling procedure, refer to the MAINTENANCE and DLN sections of the appropriate ESM, if needed.
25. Connect both battery cables, negative cable last.
26. Reset / initialize all applied systems i.e., radio, power windows, clock, sunroof, etc.
27. Test the vehicle for transfer assembly related leaks.
