Murano FWD V6-3.5L (VQ35) (2004)
Seals and Gaskets: Service and Repair
Precautions for Liquid Gasket
REMOVAL OF LIQUID GASKET SEALING
^
After removing the mounting bolts and nuts, separate the mating surface using a seal cutter and remove the liquid gasket sealing.
CAUTION: Be careful not to damage the mating surfaces.
^
In areas where the cutter is difficult to use, use a plastic hammer to lightly tap the area where the liquid gasket is applied.
CAUTION: If for some unavoidable reason a tool such as a flat-bladed screwdriver is used, be careful not to damage the mating surfaces.
LIQUID GASKET APPLICATION PROCEDURE
1. Using a scraper, remove the old liquid gasket adhering to the gasket application surface and the mating surface.
^
Remove the liquid gasket completely from the groove of the gasket application surface, mounting bolts, and bolt holes.
2. Wipe the gasket application surface and the mating surface with white gasoline (lighting and heating use) to remove adhering moisture, grease and
foreign materials.
3. Attach the liquid gasket tube to the tube presser.
Use Genuine RTV Silicone Sealant or equivalent.
4. Apply the liquid gasket without breaks to the specified location with the specified dimensions.
^
If there is a groove for the liquid gasket application, apply the gasket to the groove.