Murano FWD V6-3.5L (VQ35) (2004)
/Page-615006.png)
26. Remove chain tension guide.
27. Remove rear timing chain case as follows:
a. Loosen and remove mounting bolts in reverse order as shown.
b. Cut the sealant using a seal cutter [special service tool: KV10111100 (J37228)] or an equivalent tool and remove rear timing chain case.
CAUTION:
^
Do not remove plate metal cover of oil passage.
^
After removing chain case, do not apply any load which affects flatness.
28. Remove RH and LH camshaft chain tensioners from cylinder head as follows if necessary.
a. Remove No.1 camshaft brackets.
b. Remove secondary chain tensioners with stopper pin attached.
29. Use a scraper to remove all traces of liquid gasket from front and rear timing chain cases, and opposite mating surfaces.
^
Remove old liquid gasket from the bolt hole and thread.