Murano FWD V6-3.5L (VQ35) (2004)
Electronic Brake Control Module: Service and Repair
ABS/EBD
ACTUATOR AND ELECTRIC UNIT (ASSEMBLY)
ABS/EDB ACTUATOR AND ELECTRIC UNIT (ASSEMBLY)
Removal and Installation
Pay attention to the following when removing actuator.
CAUTION: Before servicing, disconnect battery cables.
To remove brake tube, use flare nut wrench to prevent flare nuts and brake tube from being damaged. To install, use flare nut wrench
(commercial service tool).
Do not remove and install actuator by holding harness.
After work is completed, bleed air from brake piping.