Murano FWD V6-3.5L (VQ35) (2004)
Clockspring Assembly / Spiral Cable: Service and Repair
SPIRAL CABLE
Removal and Installation
REMOVAL
CAUTION: Before servicing SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes.
1. Remove driver air bag module.
2. Set the steering wheel in the neutral position.
3. Remove steering wheel with steering wheel puller.
CAUTION: Be careful not to over-tighten puller on steering wheel.
4. Remove the column cover upper and lower.
5. Loosen the spiral cable fixing screws, and then remove the spiral cable.
CAUTION:
-
Do not disassemble spiral cable.
-
Do not apply lubricant to the spiral cable.