Murano FWD V6-3.5L (VQ35) (2004)
10.
Remove the Battery from the vehicle.
11.
Re-position the Battery Tray as follows:
a.
Remove five Bolts that secure the Battery Tray to the vehicle (see Figure 11).
b.
Re-position the Battery Tray to make room for removing the Cooling Fan Assembly (covered later in this procedure).
CAUTION:
Make sure the vehicle's cooling system is completely cooled down before performing the next step.
12.
Disconnect the Upper Radiator Hose from the Radiator as follows:
a.
Carefully remove the Radiator Cap.
b.
To avoid spilling, remove all of the coolant from the radiator upper tank.
^
Remove the drain plug at the radiator lower tank.
^
Drain and "capture" enough coolant to drop the level below the upper tank.
NOTE:
The 0-Ring on the Drain Plug will have to be replaced. The 0-Ring P/N is: 21481-18000.
c.
After the upper tank is empty, disconnect the Upper Radiator Hose from the Radiator (see Figure 12).
13.
Remove the Cooling Fan Assembly as follows: