Murano FWD V6-3.5L (VQ35) (2004)
Seals and Gaskets: Service and Repair
Side Oil Seal
SIDE OIL SEAL / REMOVAL
1. Remove rear wheel sensor.
2. Remove rear axle assembly.
3. Remove rear drive shaft.
4. Using flat tip screwdriver as shown in the figure, remove side oil seal.
INSTALLATION
1. Apply multi-purpose grease to sealing lips of oil seal.
2. Using the drift, press-fit oil seal so that its surface comes face to face with the end surface of the case.
Tool number:....................A: KV38100200 (J26233)
Tool number:....................B: ST27861000 (-)
CAUTION: When installing the oil seal be careful not to get it inclined.
Discard the old oil seal. Always replace with new one.
3. Install rear drive shaft.
4. Install rear axle assembly.