Murano FWD V6-3.5L (VQ35) (2004)
INSTALLATION
Paying attention to following items, install in the reverse order of removal.
Align mating marks to install propeller shaft, and tighten to specified torque.
Adjust location of mounting bracket back and forth to prevent longitudinal give of insulator as shown. Install bracket to vehicle.
After assembly, perform a driving test to check propeller shaft for runout. If a runout is detected, separate propeller shaft from final drive. Reinstall
companion flange after rotating it by 90°, 180°, and 270°. Then perform driving test and check propeller shaft runout again at each point.