Murano FWD V6-3.5L (VQ35DE) (2006)
REMOVAL
1. Remove rear combination lamp assembly.
2. Remove bumper fascia bolts from both right/left rear fender.
3. Remove upper portion of bumper fascia clips, and remove clips of lower portion.
4. Pull out center of bumper fascia, and pull out side of bumper fascia from clips.
5. Remove bumper fascia assembly.
CAUTION: When removing bumper fascia, 2 workers are required so as to prevent it from dropping.
6. Remove rear bumper energy absorber.
7. Remove bumper reinforcement nuts and remove bumper reinforce assembly.
INSTALLATION
Install in the reverse order of removal.
NOTE: After installation, adjust the clearance.
REAR BUMPER CLOSING
Removal
1. Remove clips of bumper closing.
2. Remove bumper closing.
Installation
Install in the reverse order of removal.
DRAFTER GUARD
Removal
1. Remove nut and bolt of drafter guard.
2. Remove drafter guard assembly.