Murano FWD V6-3.5L (VQ35DE) (2006)
1.
Using a screwdriver remove 2 screws and foam bottom.
2.
Remove cup holder assembly.
3.
Insert new cup holder assembly by lining up the 2 hooks with the 2 square holes.
4.
Push the cup holder assembly down and back then forward to insert the hooks into the holes.
NOTE:
Be careful not to damage adjuster flaps.
5.
Install the original 2 screws.
6.
Lightly spray soapy water on adhesive side of foam bottom.
7.
Carefully install foam bottom in cup holder insert. Use a squeegee or similar tool to bond the foam bottom to the cup holder insert.
SERVICE PROCEDURE II