Murano FWD V6-3.5L (VQ35DE) (2006)
Trunk / Liftgate Weatherstrip: Service and Repair
Removal and Installation of Back Door Weatherstrip
REMOVAL
Pull up and remove engagement with body from weatherstrip joint.
CAUTION: After removal, do not pull strongly on the weatherstrip.
INSTALLATION
1. Working from the upper section, align weatherstrip mark with vehicle center position mark and install weatherstrip onto the vehicle.
2. For the lower section, align the weatherstrip seam with center of the striker.
3. After installation, pull the weatherstrip gently to ensure that there is no loose section.
NOTE: Make sure the weatherstrip is fit tightly at each corner and back door rear plate.
Emergency Unlock Lever
NOTE: If the back door cannot be opened with the back door lock opener switch or remote controller to a discharged battery, follow the next steps.
1. Remove back door finisher cover.
2. Move the emergency unlock lever to open the back door.