Murano FWD V6-3.5L (VQ35DE) (2006)
WITH ADJUSTABLE PEDAL
REMOVAL
CAUTION:
^
Adjust mechanism (Drive wire, Drive motor) is not able to disassemble.
^
Before removing pedal drive cable, pedals must be in the front position to keep the proper position between accelerator and brake pedal.
1. Remove front kicking plate (driver side).
2. Remove front body side welt (driver side).
3. Remove instrument driver lower panel.
4. Remove dash side finisher (driver side).
5. Remove parking brake pedal assembly.
6. Disconnect accelerator pedal drive cable, drive motor harness connector. (With adjustable pedal)
7. Remove stop lamp switch and ASCD cancel switch from the pedal assembly.
8. Remove snap pin and clevis pin from input rod clevis.
9. Remove mounting nuts from pedal bracket, and remove pedal assembly from vehicle.