Murano FWD V6-3.5L (VQ35DE) (2006)
Parking Brake Control: Adjustments
ADJUSTMENT
^
To perform adjustment operations, remove tire from the vehicle with power tool.
1. Insert a deep socket wrench to rotate adjusting nut and loosen the cable sufficiently. Then, return the pedal to the free height.
2. Using wheel nuts, fix the disc to the hub and prevent it from tilting.
3. Remove adjusting hole plug installed on the disc rotor. Using a screwdriver, turn the adjuster as shown in the figure until the disc rotor is locked.
After locking, turn the adjuster in the opposite direction by 5 or 6 notches.
4. Rotate the disc rotor to make sure there is no drag. Install the adjusting hole plug.
5. Adjust cable as follows:
a. Operate pedal 10 or more times with a force of 294 N (30 kg, 66 lb).
b. Rotate adjusting nut with deep socket to adjust pedal stroke.
NOTE: Do not reuse the adjusting nut after removing it.
c. When parking brake pedal is operated with a force of 196 N (20 kg, 44 lb), make sure the stroke is within the specified number of notches.
(Check it by listening and counting the ratchet clicks.)
Pedal stroke: 3 to 4 notches
d. With the pedal completely returned, make sure there is no drag on the rear brake.