Murano FWD V6-3.5L (VQ35DE) (2006)
Brake Switch (Cruise Control): Testing and Inspection
Component Tests
Component Inspection
ASCD BRAKE SWITCH
1. Turn ignition switch OFF.
2. Disconnect ASCD brake switch harness connector.
3. Check continuity between ASCD brake switch terminals 1 and 2 under the following conditions.
If NG, adjust ASCD brake switch installation, refer to "BRAKE PEDAL", and perform step 3 again.
STOP LAMP SWITCH
1. Turn ignition switch OFF.
2. Disconnect stop lamp switch harness connector.
3. Check continuity between stop lamp switch terminals 3 and 4 under the following conditions.
If NG, adjust stop lamp switch installation, refer to "BRAKE PEDAL", and perform step 3 again.