Murano FWD V6-3.5L (VQ35DE) (2006)
Air Door Actuator / Motor: Service and Repair
Air Mix Door Motor
AIR MIX DOOR MOTOR
Removal and Installation
REMOVAL
Driver Side
1. Set the temperature control dial (driver side) at 18 degrees C (60 degrees F), and then disconnect the battery cable from the negative terminal.
2. Remove instrument driver lower panel.
3. Remove mounting screws, and then remove air mix door motor.
4. Disconnect air mix door motor connector.
Passenger Side
1. Set the temperature control dial (passenger side) at 18 degrees C (60 degrees F), and then disconnect the battery cable from the negative terminal.
2. Remove blower unit.
3. Remove mounting screws, and then remove air mix door motor.
4. Disconnect air mix door motor connector.
INSTALLATION
Installation is basically the reverse order of removal.