Murano FWD V6-3.5L (VQ35DE) (2006)
8. Disconnect cooling fan connector.
9. Remove cooling fan harness clips from fan shroud.
10. Remove ground harness terminal mounting bolt.
11. Disconnect one-touch joint of high-pressure pipe 1.
a. Set a disconnector (SST: 9253089908) on A/C piping.
b. Slide a disconnector toward vehicle front until it clicks.
c. Slide A/C piping toward vehicle front and disconnect it.
CAUTION: Cap or wrap the joint of the pipe with suitable material such as vinyl tape to avoid the entry of air.
12. Remove mounting bolt, and then remove high-pressure pipe 1.
CAUTION: Cap or wrap the joint of the pipe with suitable material such as vinyl tape to avoid the entry of air.
INSTALLATION
Installation is basically the reverse order of removal.
CAUTION:
-
Replace O-rings of high-pressure pipe 1 with new ones, and then apply compressor oil to it when installing it.
-
Connection point for female-side piping is thin. So, when inserting male-side piping, take care not to deform female-side piping. Slowly insert in
axial direction.
-
Insert one-touch joint connection point securely until it clicks.
-
After piping has been connected, pull male-side piping by hand to make sure piping does not come off.
-
When recharging refrigerant, check for leaks.
Low-Pressure Pipe 2 and High-Pressure Pipe 2
Removal and Installation of Low-Pressure Pipe 2 and High-Pressure Pipe 2
REMOVAL