Murano FWD V6-3.5L (VQ35DE) (2006)
Checking Equipment
CAUTION:
-
If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on
control unit which carry out CAN communication.
-
If CONSULT-II CONVERTER is not connected with CONSULT-II, vehicle occur the "FAIL SAFE MODE" which is "LIGHT UP the HEAD
LIGHT" and/or "COOLING FAN ROTATING" when CONSULT-II is started.
-
Previous CONSULT-II "I" and "Y" DLC-I and DLC-II cables should NOT be used anymore because their DDL connector pins can be damaged
during cable swapping.
NOTE:
-
The CONSULT-II must be used in conjunction with a program card. CONSULT-II does not require loading (Initialization) procedure.
-
Be sure the CONSULT-II is turned off before installing or removing a program card.
CONSULT-II Start Procedure
NOTE: Turning ignition switch off when performing CAN diagnosis could cause CAN memory to be erased.
1. Connect CONSULT-II and CONSULT-II CONVERTER to the data link connector.
2. If necessary, turn on the ignition switch.
3. Touch "START (NISSAN BASED VHCL)" or System Shortcut key (eg: ENGINE) on the screen.