Murano FWD V6-3.5L (VQ35DE) (2006)
Brake Bleeding: Service and Repair
Bleeding Brake System
CAUTION: While bleeding, pay attention to master cylinder fluid level.
1. Turn ignition switch OFF and disconnect ABS actuator and electric unit (control unit) connector or battery cables.
2. Connect a vinyl tube to the rear right bleed valve.
3. Fully depress brake pedal 4 to 5 times.
4. With brake pedal depressed, loosen bleed valve to let the air out, and then tighten it immediately.
5. Repeat steps 3, 4 until no more air comes out.
6. Tighten bleed valve to specified torque.
7. In steps 2 to 6 below, with master cylinder sub tank filled at least half way, bleed air from the front left, rear left, and front right tires, in that order.