Murano FWD V6-3.5L (VQ35DE) (2006)
Fluid - CVT: Service and Repair
Changing CVT Fluid
Changing CVT Fluid
1. Warm up CVT fluid by driving the vehicle for 10 minutes.
^
<- Vehicle front
^
Radiator (2)
^
CVT fluid cooler hose [inlet side (3)]
^
Transaxle assembly (4)
2. Drain CVT fluid from CVT fluid cooler hose [outlet side (1)] and refill with new CVT fluid at CVT fluid charging pipe with the engine running at
idle speed.
3. Refill until new CVT fluid comes out from CVT fluid cooler hose [outlet side (1)].
About 30 to 50% extra fluid will be required for this procedure.
CVT fluid: Genuine NISSAN CVT fluid NS-2
Fluid capacity: Approximately 10.2 L (10 - 6/8 US qt, 9 Imp qt)
CAUTION:
^
Use only Genuine NISSAN CVT fluid NS-2. Do not mix with other fluid.
^
Using CVT fluid other than Genuine NISSAN CVT fluid NS-2 will deteriorate in driveability and CVT durability, and may damage the CVT,
which is not covered by the warranty.
^
When filling CVT fluid, take care not to scatter heat generating parts such as exhaust.
^
Delete CVT fluid deterioration date with CONSULT-II after changing CVT fluid.
4. Check fluid level and condition.