Murano FWD V6-3.5L (VQ35DE) (2006)
Air Bag Control Module: Service and Repair
DIAGNOSIS SENSOR UNIT
Removal and Installation
REMOVAL
CAUTION: Before servicing SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes.
1. Disconnect each harness connector for the air bag module and seat belt pre-tensioner.
2. Remove center console.
3. Disconnect diagnosis sensor unit connector.
4. Remove the bolts from the diagnosis sensor unit.
Hex bolts: 24.5 N.m (2.5 kg-m, 18 ft-lb)
Ground bolt: 6.9 N.m (0.7 kg-m, 61 in-lb)
CAUTION:
-
Do not use old bolts. Replace with new ones.
-
Check diagnosis sensor unit bracket to ensure it is free of deformities, dents, cracks or rust. If it shows any visible signs of damage, replace with
new one.
-
Replace diagnosis sensor unit if it has been dropped or sustained an impact.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
Check the diagnosis sensor unit for proper installation.
-
After replacement of diagnosis sensor unit, perform self-diagnosis to make sure no malfunction is detected. Refer to SRS-19, "SRS Operation
Check". See: Testing and Inspection/Component Tests and General Diagnostics
ECU DISCRIMINATED NO.
After replacing the diagnosis sensor unit, confirm that the diagnosis sensor unit identification is correct for the vehicle as equipped.