Murano FWD V6-3.5L (VQ35DE) (2006)
Technical Service Bulletin # 06-084
Date: 061120
A/T, Engine Controls - MIL ON/DTC P0840/Low Power
Classification: AT06-002
Reference: NTB06-084
Date: November 20, 2006
MURANO; MIL ON - P0840 - LACK OF POWER
APPLIED VEHICLE(S):
2003 - 2007 Murano (Z50)
IF YOU CONFIRM
The MIL is on with DTC P0840 stored in the TCM.
ACTIONS
Step A: Remove the original valve body and install the parts listed in the Parts Information section of this bulletin.
IMPORTANT:
Make sure to erase the EEPROM (see step 28).
Step B: Reprogram the TCM.
PRECAUTIONS WHEN REPLACING CVT VALVE BODY ASSEMBLY
1.
If other DTCs are combined W/P0840, resolve them first. Refer to ASIST and the Service Manual for diagnostic information.
2.
If you observe excessive contamination in the oil pan and/or can isolate an unusual noise coming from the transmission, this TSB does not apply.
Refer to the Service Manual for further assistance.
3.
Transmissions are very vulnerable to particles (dust, metal, etc.).
^
When replacing a CVT valve body, make sure your work environment (shop, workbench, etc.) the transmission area (sub-frame, oil pan,
harness connector, etc.) and your hands are free of contamination.
^
Make sure all parts are clean prior to installing on the vehicle.
^
Unpack Service Parts just before installation.
IMPORTANT:
The purpose of "ACTIONS" (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire
Service Procedure as it contains information that is essential to successfully completing this repair.
PARTS INFORMATION