Murano FWD V6-3.5L (VQ35DE) (2006)
^
There are 11 bolts shown and numbered for convenience.
^
There are 3 different length bolts which are identified by:
S-short
M-medium
L-long
13.
Remove the valve body. Note the position of the Ratio Control Valve and attached shift link.
14.
Make sure you replace the 2 lip seals shown in Figure 11.
^
Do not reuse the old lip seals.
^
Use petroleum jelly to keep the new lip seals in place during reassembly.
15.
Carefully unpack the new valve body assembly. When installing the new valve body, be careful not to allow the Ratio Control Valve to fall out
(see Figure 10).
^
If the Ratio Control Valve does fall out, check the condition of all surfaces especially the edges for damage.
^
Confirm (double check) the direction of the shift link and the bottom of the shift link around the step motor pin (see Figure 12).