Murano FWD V6-3.5L (VQ35DE) (2006)
3.
Check the CONSULT-II's "Charger Input" reading (see Figure D).
NOTE:
^
"Battery Voltage" is the voltage level of CONSULT-II's battery.
^
"Charger Input" is the voltage level of the vehicle's battery. (It must be above 12 volts.)
Step Three: Reprogram the TCM
Step Four: TCM Reprogramming "Wrap-up"
1.
Turn the ignition and CONSULT-II OFF.
2.
Disconnect CONSULT-II from the vehicle.
3.
Start the Engine and make sure the MIL is OFF.
^
If it's still ON, use CONSULT-II with the Diagnostic (red/white) Card to erase any DTC's that may have stored in the TCM and/or the ECM
during the reprogramming procedure.
4.
Confirm there are no leaks from the transmission. Test-drive the vehicle and make sure the transmission operates correctly in all modes and has a
normal power level when starting from a stop.
See the AT section of the appropriate Service Manual for operation specifications.