Pathfinder 2WD V6-3.5L (VQ35) (2003)
Acceleration/Deceleration Sensor: Service and Repair
Removal and Installation
Pay attention to the following when removing actuator.
CAUTION:
^
Before servicing, disconnect battery cables.
^
To remove brake tube, use a flare nut wrench to prevent flare nuts and brake tube from being damaged. To install, use a brake tube torque wrench
(commercial service tool).
^
Do not remove and install actuator by holding harness.
^
After work is completed, bleed air from brake piping.
REMOVAL
1. Remove center console.
2. Remove harness connector.
3. Remove installation bolts. Remove yaw rate/side/decel G-sensor.
CAUTION: Do not drop or strike the yaw rate/side/decel G-sensor, because it has little endurance to impact.
INSTALLATION
To install, follow procedure for removal in reverse order.
CAUTION: Do not drop or strike the yaw rate/side/decel G-sensor, because it has little endurance to impact.