Pathfinder 2WD V6-4.0L (VQ40DE) (2009)
Yaw Rate Sensor: Service and Repair
Type 2 - Hill Descent Control/Hill Start Assist/VDC/TCS/ABS
G SENSOR
Removal and Installation
REMOVAL
1. Remove the center console. Refer to See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Exploded View.
2. Remove the yaw rate/side/decel G sensor nuts as shown.
CAUTION:
-
Do not use power tools to remove or install the yaw rate/side/decel G sensor.
-
Do not drop or strike the yaw rate/side/decel G sensor.
NOTE:
The location of the yaw rate/side/decel G sensor is the same for all models.
3. Disconnect the yaw rate/side/decel G sensor connector and remove the yaw rate/side/decel G sensor.
INSTALLATION
Installation is in the reverse order of removal.
-
After installing the yaw rate/side/decel G sensor, it is necessary to calibrate the yaw rate/side/decel G sensor. Refer to See: Antilock Brakes /
Traction Control Systems/Testing and Inspection/Programming and Relearning/Calibration Of Decel G Sensor/Special Repair Requirement/Type
2 - Hill Descent Control/Hill Start Assist/VDC/TCS/ABS.