Pathfinder 4WD V6-3.5L (VQ35) (2004)
6. Remove wheel bearing look nut.
7. Remove wheel hub and wheel bearing.
Be careful not to drop outer bearing.
INSTALLATION
1. After installing wheel hub and wheel bearing, adjust wheel bearing preload. Refer to "Preload Adjustment", "FRONT WHEEL BEARING".
2. Pack drive flange groove with grease, apply grease to O-ring (two places) and mating surface of drive flange, and install flange. - 4WD -
3. Install snap ring. - 4WD -
4. Install hub cap using a suitable tool.
Do not reuse hub cap. When installing, replace it with a new one.
DISASSEMBLY