Pathfinder 4WD V6-3.5L (VQ35) (2004)
Accelerator Pedal: Service and Repair
Removal and Installation
Removal and Installation
CAUTION:
-
Check that throttle valve opens when accelerator pedal is fully depressed. Also check that it returns to idle position when pedal is released when
ignition switch is in "ON" position.
-
Check accelerator control parts for improper contact with any adjacent parts.
REMOVAL
1. Remove harness connector.
2. Remove mounting nut then remove accelerator pedal assembly.
CAUTION:
-
Do not disassemble accelerator pedal or remove/install accelerator pedal position sensor.
-
Do not drop or shock accelerator pedal assembly.
-
Keep accelerator pedal assembly from getting wet.
INSTALLATION
Install in reverse order of removal.
INSPECTION AFTER INSTALLATION
-
Check if accelerator pedal moves smoothly within its range.
-
heck if accelerator pedal returns securely to its original position.
-
Perform "Accelerator Pedal Released Position Learning" when removing the accelerator pedal position sensor harness connector. Refer to
"BASIC SERVICE PROCEDURE".
-
For electrical inspection of accelerator pedal assembly refer to "DTC P2138 APP SENSOR". See: Computers and Control Systems/Testing
and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/P Code Charts/P2138