Pathfinder 4WD V6-4.0L (VQ40) (2005)
^
This will add the data you selected to the "File(s) Selected" list.
4.
Write the "To" number on the Repair Order.
5.
Click on "Continue" and follow directions to perform "data transfer" (download) from ASIST into CONSULT-II.
Step Two: Preparation for Reprogramming ECM
1.
Connect a battery charger to the vehicle's battery. Set the charger to a low charge rate (trickle charge).
CAUTION:
For number 2 below and number 3, DO NOT connect the CONSULT-II A/C Power Supply.
2.
Press [SUB MODE] (see Figure C) then:
a.
From the listed items, find and select BATTERY CHARGE.
3.
Check the CONSULT-II's "Charger Input" reading (see Figure D).
NOTE:
^
"Battery Voltage" is the voltage level of the CONSULT-II battery.
^
"Charger Input" is the voltage level of the vehicle's battery. It must be above 12 volts.
CAUTION:
If the "Charger Input" is below 12 volts: