Pathfinder 4WD V6-4.0L (VQ40) (2005)
1. Install the oil seal until it is flush with the end face of the front case, using Tool.
Tool number: KV38100500 ( - )
CAUTION:
^
Do not reuse oil seal.
^
Apply petroleum jelly to oil seal.
2. Align the matching mark of the front drive shaft with the matching mark of the companion flange, then install the companion flange.
3. Install the self-lock nut. Tighten to the specified torque, using Tool. Refer to image.
Tool number: KV40104000 ( - )
CAUTION: Do not reuse self-lock nut.
4. Install the front propeller shaft. Refer to "INSTALLATION"
5. Refill the transfer with fluid and check fluid level. Refer to "FILLING".
6. Check the transfer for fluid leakage. Refer to "FLUID LEAKAGE AND FLUID LEVEL".
Rear Oil Seal
REAR OIL SEAL
Removal and Installation
REMOVAL
1. Partially drain the transfer fluid. Refer to "DRAINING".
2. Remove the rear propeller shaft. Refer to "REMOVAL".