Pathfinder 4WD V6-4.0L (VQ40DE) (2006)
Front Door Window Glass: Service and Repair
Removal and Installation
FRONT DOOR GLASS AND REGULATOR
Front Door Glass
REMOVAL
1. Remove the front door finisher.
2. Temporarily reconnect the power window switch.
3. Operate the power window main switch to raise/lower the door window until the glass bolts can be seen.
4. Remove the inside seal.
5. Remove the glass bolts.
6. While holding the door window, raise it at the rear and pull the glass out of the sash toward the outside of the door.
INSTALLATION
Installation is in the reverse order of removal.
Glass bolts : 6.1 N.m (0.62 kg-m, 54 in-lb)
-
Check the glass for proper fit. Refer to "FITTING INSPECTION".
-
On the drivers door, reset the motor. Refer to "SETTING AFTER INSTALLATION". See: Windows and Glass/Windows/Adjustments
FITTING INSPECTION
-
Check that the glass is securely fit into the glass run groove.
-
Lower the glass slightly [approximately 10 to 20 mm (0.39 to 0.79 in)] and check that the clearance to the sash is parallel. If the clearance
between the glass and sash is not parallel, loosen the regulator bolts, guide rail bolts, and glass and guide rail bolts to correct the glass position.
Front Door Glass Regulator
REMOVAL
1. Remove the front door finisher.
2. Temporarily reconnect the power window switch.