Pathfinder 4WD V6-4.0L (VQ40DE) (2006)
Control Module: Service and Repair
TX15B
Precautions For Transfer Assembly and Transfer Control Unit Replacement
Precautions for Transfer Assembly and Transfer Control Unit Replacement
When replacing transfer assembly or transfer control unit, check the 4WD shift indicator pattern and adjustment of the position between transfer
assembly and transfer control unit if necessary.
CHECK 4WD SHIFT INDICATOR PATTERN
1. Set 4WD shift switch to 2WD, 4H 4LO, 4H and 2WD in order. Stay at each switch position for at least 2 seconds.
2. Confirm 4WD shift indicator lamp and 4LO indicator lamp are changed properly as follows.
^
If OK, the position between transfer assembly and transfer control unit is correct.
^
If NG, the position is different between transfer assembly and transfer control unit. Adjust the position between transfer assembly and transfer
control unit. Refer to pattern table.
Transfer Position Adjustment Pattern
NOTE: Method of adjustment can be chosen voluntarily, according to location of 4WD shift switch.
Removal and Installation
TRANSFER CONTROL UNIT
Removal and Installation
REMOVAL
1. Switch 4WD shift switch to 2WD and set transfer assembly to 2WD.
CAUTION: When removing transfer control unit, transfer state must be at 2WD.
2. Turn the ignition switch OFF and disconnect negative battery terminal.
3. Remove the lower instrument panel LH.