Pathfinder LE 2WD V6-3.3L (VG33E) (1999)
Figure 3
5.
Insert the new soft foam run rubber seal in place of the hard foam rope seal (see Figure 3).
Figure 4
6.
Re-install the glass run rubber. Feed the run rubber back into the door channel (see Figure 4).
NOTE:
If the run rubber is pulled completely out of the door channel, apply a small amount of soapy water solution to it and feed it down into the door
channel.
Make sure the notch/guide on the run rubber is placed on top of the door's vertical channel (see Figure 4).
7.
Cycle the window up/down/up and test that the noise is gone.
8.
Repeat Steps 1 through 7 for the other front window, if necessary.