Pathfinder LE 2WD V6-3.3L (VG33E) (1999)
1. Set wheels in the straight-ahead position.
2. Install transfer gear assembly.
3. Install column lower joint while aligning groove with protrusions on the steering gear rear cover cap.
4. Tighten bolt while aligning groove on steering gear. Before tightening bolt, ensure it is inserted correctly.
5. When attaching steering column upper and lower joint to transfer gear, it must be positioned as shown in figure at left.
Inspection
Do not disassemble steering transfer gear assembly.
^
Check that steering transfer gear assembly operates smoothly. Also check for grease leakage, deformation and damage. Replace steering transfer
gear assembly if necessary.
^
Check rotating torque at input shaft in 360° and in both directions.
Rotating torque: 0.25 - 0.69 Nm (2.5 - 7.0 kg-cm, 2.2 - 6.1 inch lbs.)
If rotating torque is out of specification, replace steering transfer gear assembly.