Pathfinder LE 2WD V6-3.5L (VQ35) (2001)
Air Door Cable: Adjustments
With Manual Climate Control
CONTROL LINKAGE ADJUSTMENT
Intake Door Motor
1. Install intake door motor on blower and intake unit. Ensure that the intake door motor lever is fitted into the slit portion of intake door link.
2. Connect the intake door motor harness connector.
3. Turn ignition switch to ON.
4. Check that intake door operates properly when RECIRCULATION switch is turned ON and OFF.
Water Cock Control Rod
-
When adjusting water cock control rod, first disconnect temperature control cable from air mix door lever and then adjust control rod. Reconnect
temperature control cable and readjust it. (Refer to TEMPERATURE CONTROL CABLE.)
1. Push air mix door lever in direction of arrow.
2. Pull control rod of water cock in direction of arrow so as to make clearance of about 2 mm (0.08 in) between ends of rod and link lever and
connect the rod to door lever.
After connecting control rod, check it operates properly.
Temperature Control Cable
1. Move the temperature control knob to the full hot position.
2. Set the air mix door lever in the full hot position.
3. Pull on the cable cover in the direction of the arrow, then clamp it.
After positioning control cable, check that it operates properly.