Pathfinder LE 2WD V6-3.5L (VQ35) (2001)
8. Remove gear housing end cover assembly with a suitable tool.
9. Draw out rack assembly.
10. Remove rack seal ring.
-
Using a heat gun, heat rack seal to approximately 40° C (104° F). Remove rack seal ring.
-
Be careful not to damage rack.
11. Remove rack bushing and rack oil seal using tape wrapped socket and extension bar.
Do not scratch inner surfaces of pinion housing.
Inspection
Thoroughly clean all parts in cleaning solvent or Genuine Nissan PSF II or equivalent. Blow dry with compressed air, if available.
BOOT
-
Check condition of boot. If cracked excessively, replace it.
-
Check boots for accumulation of power steering fluid.
RACK
Thoroughly examine rack gear. If damaged, cracked and worn, replace it.
PINION ASSEMBLY
-
Thoroughly examine pinion gear. If pinion gear is damaged, cracked and worn, replace it.
-
Check that all bearings roll freely. Ensure that balls, rollers and races are not cracked, pitted and worn.
GEAR HOUSING CYLINDER
Check gear housing cylinder bore for scratches and other damage. Replace if necessary.
TIE-ROD OUTER AND INNER SOCKETS
-
Check ball joints for swinging force.
Tie-rod outer and inner ball joints swinging force "A":
Refer to Specifications.
-
Check ball joint for rotating torque.
Tie-rod outer ball joint rotating torque "B":
Refer to Specifications.