Pathfinder SE 4WD V6-3.5L (VQ35) (2002)
Impact Sensor: Service and Repair
Satellite Sensor
REMOVAL AND INSTALLATION
CAUTION:
-
Before servicing SRS, turn the ignition switch off, disconnect battery ground cable and wait at least 3 minutes.
-
Do not use old bolts coated with bonding agent after removal; replace with new ones.
-
Check satellite sensor for proper installation.
-
Check satellite sensor to ensure they are free of deformities, dents, cracks or rust. If it shows any visible signs of damage, replace it with new one.
-
After replacement of satellite sensor, check SRS function and perform self-diagnosis for SRS. Refer to "SRS Operation Check" for details.
-
Do not attempt to disassemble satellite sensor.
-
Replace satellite sensor if it has been dropped or sustained an impact.
1. Remove seat belt pre-tensioner. Refer to "Front Seat Belt" for details.
2. Disconnect satellite sensor connector.
3. Remove satellite sensor fixing nuts.
Then remove the satellite sensor.
NOTE: To install, reverse the removal procedure sequence.