PL720 4WD L4-2389cc 2.4L SOHC (Z24) (1983)
*
The brake rotor run-out exceeds specification limits.
*
As the brake pad rubs against the rotor while driving, the high spots on the brake rotor wear slightly.
*
Rotor thickness variation may develop as the high spots on the brake rotor wear. If this thickness variation becomes large enough, brake
judder/shimmy may occur.
NISSAN SERVICE PROCEDURE:
Resurfacing the brake rotor using the Ammco On-Car Brake Lathe is the preferred method of correcting excessive rotor run-out and thickness variation.
Refer to Nissan Technical Bulletin NTB92-062 (BR92-004) "Ammco On-Car Brake Lathe Operating Guidelines."