Pulsar L4-1597cc 1.6L SOHC (E16i) (1987)
Window Glass: All Technical Service Bulletins
Windows - Door Glass Adjustment
Reference:
TECHNICAL BULLETIN TS87-029 Date: February 20, 1987
Classification:
BF87-005 Section: Body & Frame Models: 1987 Pulsar NX
DOOR WINDOW ADJUSTMENT
APPLIED MODEL: 1987 Pulsar NX
SERVICE INFORMATION
FIGURE 1 - Door Window Adjustment
Some 1987 Pulsar NX vehicles may have improperly adjusted door window glass, causing the window to remain outside of the upper door glass stopper
when the door is closed with the window in the full up position (Figure 1). This can be corrected by adjusting the door glass tilt angle described below.
SERVICE PROCEDURE
1.
Make sure that the door is properly adjusted.
2.
Remove the interior door trim panel.
FIGURE 2 - Glass Stabilizer/Regulator Adjusting Screws
3.
Loosen the bolt for the rear glass stabilizer (Figure 2).
4.
Loosen the lock nuts on the regulator adjustment screws (Figure 2) and turn the adjustment screws counter-clockwise to lean the window glass
inward at the top.