Pulsar L4-1809cc 1.8L DOHC (CA18DE) (1988)
Ball Joint: Service and Repair
1.
Remove wheel bearing locknut.
2.
Remove tie rod ball joint.
2.
Remove strut lower bracket attaching nuts and bolts.
3.
Separate driveshaft from knuckle by tapping driveshaft end with a suitable hammer. Use caution not to damage driveshaft boots.
4.
Separate lower ball joint stud from knuckle using a suitable tool.
5.
Remove stabilizer bar attaching bolt from transverse link and ball joint assembly.
6.
Remove transverse link bracket attaching bolts, then the transverse link bracket.
7.
Remove remaining transverse link assembly attaching bolt, then the transverse link and ball joint assembly.
8.
Reverse procedure to install.