Quest V6-3.5L (VQ35DE) (2009)
8. Remove the TORX bolts (T30) and the door lock assembly.
Door lock assembly bolts : 5.3 Nm (0.54 kg-m, 47 in-lb)
9. Remove the TORX bolt (T30) from the outside handle bracket.
10. While pulling the outside handle bracket, slide it toward the rear of the vehicle to remove it and the door lock assembly.
11. Disconnect the door lock actuator electrical connector.
12. Separate the outside handle cable connection from the outside handle bracket.
Installation is in the reverse order of removal.
CAUTION:
To install each rod, be sure to rotate the rod holder until a click is felt.