Quest V6-3.5L (VQ35DE) (2009)
Sliding Door Interior Trim Panel: Service and Repair
DOOR FINISHER
Removal and Installation
FRONT DOOR
Removal
1. Release clip and remove front corner cover.
2. Remove screw cover then screw from cup of power window and door lock/unlock switch assembly.
3. Remove power window and door lock/unlock switch assembly.
-
Release clip and disconnect harness connectors.
4. Remove memory seat/fuel door release switch assembly.
-
Release clip and disconnect harness connectors.
5. Remove step light.
-
Release tab and disconnect harness connectors.
6. Remove door finisher and disconnect lock cable and handle cable from door handle assembly.
-
Release clips and remove door lock cable and door handle cable. Refer to See: Front Door/Locations See: Front Door/Front Door Latch/Service
and Repair.
7. Remove screws and front door release handle from front door finisher.