Quest V6-3.5L (VQ35DE) (2009)
Shift Indicator: Testing and Inspection
A/T INDICATOR
A/T Indicator Does Not Illuminate
1.CHECK COMBINATION METER INPUT SIGNAL
1. Select "METER/M&A" on CONSULT-III.
2. Using "DATA MONITOR", confirm each indication while operating the shift lever.
NOTE:
If more than one input is ON, A/T indicator will enter fail-safe function and the display will turn off.
OK or NG
OK - Replace combination meter. Refer to See: Dashboard / Instrument Panel/Service and Repair/Combination Meter.
NG - GO TO 2.
2.CHECK TCM
Perform self-diagnosis of TCM. Refer to See: Powertrain Management/Transmission Control Systems/Testing and Inspection/Scan Tool Testing and
Procedures.
OK or NG
OK - Replace combination meter. Refer to See: Dashboard / Instrument Panel/Service and Repair/Combination Meter.
NG - Perform "Diagnostic Procedure" for displayed DTC.